Standard

SAE J2596

Publisert

Merknad: Denne standarden har en ny utgave: SAE J2596

For bestilling og priser av dette produktet ta kontakt med salg@standard.no

Omfang

This SAE Part Standard covers selected inch dimensioned tapping screws and metallic drive screws manufactured in accordance with American Society for Mechanical Engineers dimensional standards. This SAE standard covers material most often used in ship systems and equipment but its use may be applied wherever fasteners of the covered materials are used. This standard permits the fasteners to be identified and ordered by a Part Identification Number (PIN) as defined in this standard. Purpose The purpose of this document is to assist the designer and other personnel in providing requirements and Part Identification Numbers (PINs) for the most commonly used tapping and metallic drive screws. A PIN is normally required for all military applications and provides a useful means of communicating screw requirements to suppliers and manufacturers in a very succinct manner. Tapping Screws and Metallic Drive Screw Part Numbers This document provides PINs that can be used to identify the screws covered by this standard. The parts covered by this standard are manufactured in accordance with materials and processes identified in applicable standards issued by ASME, ASTM, IFI and SAE. The PIN identifies the type thread and point, nominal diameter, head style and drive, nominal length, fastener material, and finish (coating). Safety - Hazardous Materials While the materials, methods, applications, and processes described or referenced in this specification may involve the use of hazardous materials, this specification does not address the hazards that may be involved in such use. It is the responsibility of manufacturers and users to consult with officials on the applicable health and environmental regulations regarding the handling, use and disposal of hazardous materials. For fasteners, some of the hazardous materials concerns are the application of the materials in platings (coatings), release of toxic vapors due to heat (for example, welding) and environmental regulations for disposal.

Dokumentinformasjon

  • Standard fra SAE_AC
  • Publisert:
  • Versjon: 0
  • Varetype: IS