Standard

SAE J126

Revidert
For bestilling og priser av dette produktet ta kontakt med salg@standard.no

Omfang

This SAE Recommended Practice outlines a procedure for se¬lecting the proper specification for carbon steel sheet and strip which are purchased to make an identified part, Specifications considered are: ASTM A 109, Steel, Carbon, Cold Rolled Strip. ASTM A 569, Steel, Carbon (0,15 maximum percent), Hot Rolled Sheet, Commercial Quality (HRCQ). ASTM A 621, Steel, Sheet, Carbon, Hot Rolled, Drawing Quality (HRDQ). ASTM A 622, Steel, Sheet, Carbon, Hot Rolled, Drawing Quality, Special Killed (HRDQSK). ASTM A 568, Steel, Carbon and High-Strength Low-Alloy Hoi Rolled Sheet, and Cold Rolled Sheet, General Requirements. ASTM A 366, Steel, Carbon, Cold Rolled Sheet, Commercial Quality (CRCQ). ASTM A 619, Steel, Sheet, Carbon, Cold Rolled, Drawing Quality, (CRDQ). ASTM A 620, Steel, Sheet, Carbon, Cold Rolled, Drawing Quality, Special Killed (CRDQSK). ASTM A 749M, Steel, Carbon and High-Strength Low-Alloy, Hot Rolled Strip, General Requirements. ASTM A 635, Steel Sheet and Strip, Carbon, Hot Rolled Commercial Quality, Heavy Thickness Coils. (Metric ASTM documents are designated by suffix M) It also describes how codes or symbols for specifying certain characteristics may be used in electronic data processing systems. Characteristics covered are: (A) Hot or cold rolled. (B) Sheet or strip. (C) Severity of draw {quality of steel}. (D) Surface condition (finish, etc.), (E) Edge condition. (F) Dimensions. It is intended that other characteristics and part identification be covered by a supplement to the specification, as necessary.

Dokumentinformasjon

  • Standard fra SAE_AC
  • Publisert:
  • Versjon: 0
  • Varetype: IS