Handlevagon 0
Standard

NS-EN ISO 899-2:2024

Publisert
Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

This document specifies a method for determining the flexural creep of plastics in the form of standard test specimens under specified conditions such as those of pre-treatment, temperature and humidity. It is only applicable to a simple freely supported beam loaded at mid-span (three-point-loading test). The method is suitable for use with rigid and semi-rigid non-reinforced, filled and fibre-reinforced plastics materials (see ISO 472 for definitions) test specimens moulded directly or machined from sheets or moulded articles.NOTE The method can be unsuitable for certain fibre-reinforced materials due to differences in fibre orientationThe method is intended to provide data for engineering-design, quality control, research and development purposes.The method might not be applicable for determining the flexural creep of rigid cellular plastics (attention is drawn in this respect to ISO 1209-1 and ISO 1209-2).

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Utgave: 2024-10
  • Versjon: 1
  • Varetype: NAT
  • Products.Specs.pages
  • ICS 83.080.01
  • National Committee SN/K 609

Produktrelasjon

Produkt livssyklus