Standard

NS-EN 828:1997

Tilbaketrukket

Merknad: Denne standarden har en ny utgave: NS-EN 828:2013

Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

This European Standard specifies the determination of the ability of an adhesive to "wet" a solid surface by measuring the contact angle and determining the critical surface tension of wettability. It allows the prediction of what adhesive will wet which adherend. It may be used to characterize surfaces after priming, coating and bonding. NOTE 1: In general the contact angle takes, in dependence on the proceeding motion of the borderline of the liquid (i.e. on the mode of application), a value between two borderline values,the advancing angle (e.g. after an extension of a drop) and the receding angle (e.g. after a reduction of a drop). Only if this difference between both, termed hysteresis of contact angle, is negligible, the contact angle expresses the critical surface tension defined in thermodynamics as a substrate-specific characteristic value. Normally, the hysteresis will not be negligible when the rugosities are above 0,5 Fm and when the heterogeneous phase is not smaller than 0,1 Fm. The shape of the rugosity is essential for the hysteresis. NOTE 2: For a comparison of wetting behaviour, the advancing angle should always be measured here.

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Tilbaketrukket:
  • Utgave: 1
  • Versjon: 1
  • Varetype: NAT
  • ICS 83.180
  • National Committee SN/K 267/AG 1

Produktrelasjon

Produkt livssyklus