Handlevagon 0
Standard

NS-EN 1845:1998

Tilbaketrukket

Merknad: Denne standarden har en ny utgave: NS-EN 1845:2007

Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

1.1 This Standard applies to footwear moulding machines which are intended for use in the shoe industry for the production of footwear and footwear components. These machines are: - direct-on sole moulding machines; - full shoe and boot moulding machines; - unit sole and footwear component moulding machines. 1.2 This Standard specifies safety requirements for construction, transport, installation, adjustment, setting, teaching or process change-over, operation, cleaning, maintenance, decommissioning, dismantling and, as far as safety is concerned, disposal for machines mentioned in 1.1. It takes account of intended use, foreseeable misuse, component and system failure. 1.3 The following machines are excluded from the scope of this Standard unless used for direct-on sole moulding or reaction moulding; - moulding machines with static injection units and static mould stations (clamping units); - moulding machines with static metering and mixing units and mobile stations with linear configuration (mould carriers). 1.4 This Standard covers all hazards relevant to the footwear manufacturing industry only. (List of hazards see clause 4). The standard does not deal with: - precise technical measures for reducing the risks from fumes, - hazards created by the mixing and metering unit. Note: For metering and mixing units, see EN 1612-1. The use of machines within the scope of this Standard in industries other than those specified in 1.1 may give rise to hazards not considered during its preparation. Note: For this application see EN 201 and prEN 1612-2. 1.5 This Standard also applies to additional equipment for material handling and operation which are an integral part of the machine such as: spraying devices, injection units, casting units, nozzle cleaners,sprue pullers, mould front edge cleaners, activating devices and robots for preparatory and subsequent treatment. The standard does not deal with precise technical measures for reducing the risks from fumes. 1.6 This Standard applies to machines manufactured after its date of publication.

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Tilbaketrukket:
  • Utgave: 1
  • Versjon: 1
  • Varetype: NAT
  • Products.Specs.pages
  • ICS 61.060
  • ICS 61.080
  • National Committee CEN/TC 201

Referanser i lov

EU lov:
Lov referanseRestriksjoner
89/392/EEC
98/37/EC

Produktrelasjon

Produkt livssyklus