Standard

NS-EN 10147:1991

Tilbaketrukket

Merknad: Denne standarden har en ny utgave: NS-EN 10147:2000

Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

1.1 This European Standard specifies requirements for continuously hot-dip zinc coated flat products in thicknesses ≤ 3.0 mm made of the steels given in table 1. The thickness is the final thickness of the delivered product after zinc coating. This European Standard applies to strip of all widths and to sheets cut from it (≥ 600 mm width) and cut lengths ( 3.0 mm. In this case, the mechanical property, adhesion of coating and surface condition requirements shall also be agreed at the time of ordering. 1.3 The products covered by this European Standard are suitable for applications where the minimum yield strength values and resistance to corrosion are of prime importance. Corrosion protection afforded by the coating is directly proportional to the mass of coating (see also 5.2.2). 1.4 This European Standard is not applicable to – continuously hot-dip zinccoated low carbon steel sheet and strip for cold forming (see EN 10142); – electrolytic zinc coated flat steel products (see EURONORM 152); – continuously organic coated flat steel products (see EURONORM 169).

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Tilbaketrukket:
  • Utgave: 1
  • Versjon: 1
  • Varetype: NAT
  • ICS 77.140.50

Produktrelasjon

Produkt livssyklus