Standard

API SPEC Q1

Revidert

Merknad: Denne standarden har en ny utgave: API SPEC Q1

For bestilling og priser av dette produktet ta kontakt med salg@standard.no

Omfang

General ISO 9001:2000, Quality management systems - Requirements Introduction General This International Standard specifies requirements for a quality management system where an organization a. needs to demonstrate its ability to consistently provide product that meets customer and applicable regulatory requirements, and b. aims to enhance customer satisfaction through the effective application of the system, including processes or continual improvement of the system and the assurance of conformity to customer and applicable regulatory requirements. Note: In this International Standard, the term "product" applies only to the product intended for, or required by, a customer. This Technical Specification defines the quality management system requirements for the design, development, production, installation and service of products for the petroleum, petrochemical and natural gas industries. Application ISO 9001:2000, Quality management systems - Requirements Application All requirements of this International Standard are generic and are intended to be applicable to all organizations, regardless of type, size and product provided. Where any requirement(s) of this International Standard cannot be applied due to the nature of an organization and its product, this can be considered for exclusion. Where exclusions are made, claims of conformity to this International Standard are not acceptable unless these exclusions are limited to requirements within clause 7, and such exclusions do not affect the organization's ability, or responsibility, to provide product that meets customer and applicable regulatory requirements. Application - Supplemental Where exclusions are made, claims of conformity to this Technical Specification are not acceptable unless these exclusions are limited to requirements within the subclauses listed below in this subclause, and such exclusions do not affect the organization's ability, or responsibility, to provide product that meets customer and applicable regulatory requirements. Section 7.3 Design and development Section 7.5.1 Control of service provision Section 7.5.2 Validation of processes for production and service provision Section 7.5.4 Customer property Note: The exclusion to Section 7.5.2 only applies to the supplemental requirement of 7.5.2.1.

Dokumentinformasjon

  • Standard fra API_AC
  • Publisert:
  • Versjon: 0
  • Varetype: IS
  • Tilleggsinformasjon
    • Seventh Edition; Errata: August 2003/ISO TS29001 Adoption