Standard

SAE USCAR-15

Published

Note: This standard has a new edition: SAE USCAR-15

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

This specification establishes the requirements and test procedures for automotive miniature bulb retention devices, including wedge base sockets with integral connectors, direct wire wedge base sockets, bayonet base sockets with integral connectors, direct wire bayonet base sockets, wedge base and bayonet base sockets with circuit plate assemblies, and associated interfaces. Tests shall follow the sequence shown in the flow charts in Appendices E and F whenever the following occurs: • New design. • Design, material, or process change made to an existing device, which could affect the outcome of the test. The test sequences shown in Appendix G shall be run annually. NOTE: Production process control data collected at a shorter interval, per an approved control plan, may be substituted if approved by customer’s responsible engineer and purchasing representative.

Document information

  • Standard from SAE_AC
  • Published:
  • Version: 0
  • Document type: IS
  • Additional information
    • REVISION 4