Standard

SAE J617

Revised

Note: This standard has a new edition: SAE J617

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

This SAE Standard specifies the major dimensions and tolerances for Engine Flywheel Housings and the Mating Transmission Housing Flanges. It also locates the crankshaft flange face or the transmission pilot bore (or pilot bearing bore) stop face in relation to housing SAE flange face. This document is not intended to cover the design of the flywheel housing face mating with the engine crankcase rear face or the design of housing walls and ribs. Housing strength analysis and the selection of housing materials are also excluded. This document applies to any internal combustion engine which can utilize SAE No. 6 through SAE No. 00 size flywheel housing for mounting a transmission. Purpose This document is intended to achieve standardization in the design of "Engine Flywheel Housings" and the "Mating Transmission Housing" flanges to assure compatibility.

Document information

  • Standard from SAE_AC
  • Published:
  • Version: 0
  • Document type: IS