Standard

SAE J2321-2

Revised

Note: This standard has a new edition: SAE J2321-2

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

Scope - This specification sheet establishes requirements for a high collapse pressure configuration filter element of a specific configuration with a minimum filtration ratio of 75 for particles larger than 7 μm when designed and tested in accordance with SAE J2321 and this specification sheet. Part or Identifying Number - Filter elements can be identified and ordered using part identifying numbers as follows: FILTRATION RATIO - (Currently only the following rating is covered.) −7 = Minimum Filtration Ratio of 75 for particles greater than 7 µm(c) SEAL MATERIAL - The O-ring to be supplied with the element shall be of the size specified in Figure 1 and with material as designated as follows: No designation = Supplied without O-ring F = Fluorocarbon rubber per SAE AS3209-224 N = Nitrile rubber per AMS-P-83461/1-224 X = Seal material as designated by purchaser

Document information

  • Standard from SAE_AC
  • Published:
  • Version: 0
  • Document type: IS