Standard

SAE J2321-1

Revised

Note: This standard has a new edition: SAE J2321-1

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

1. Scope--This specification sheet establishes requirements for low collapse pressure elements of a specific configuration with various efficiency ratings designed and tested in accordance with SAE J2321 and the requirements of this specification sheet. 1.1 Classification 1.1.1 FILTER ELEMENTS--Filter elements covered by this specification sheet shall be designated using part or identifying numbers (PIN's) as follows: EXAMPLE 1--J2321/1-6-F is an element with the configuration in accordance with SAE J2321-1 with a minimum Filtration Ratio of 75 for particles 6 μm and larger and supplied with fluorocarbon rubber seals. EXAMPLE 2--J2321/1-10 is an element with the configuration in accordance with SAE J2321-1 with a minimum Filtration Ratio of 75 for particles 10 μm and larger and is supplied without any O-rings. 1.1.2 SEAL MATERIALS--The O-rings shall be of a SAE AS568 standard size and the material for the O-ring seals shall be designated as follows: No designation = Suplied without O-rigns −F = Fluorocarbon rubber (see 3.1.11) −N = Nitrile per AMS-R-83461/1 (see 3.1.11) −X = Seal material as designated by purchaser 1.1.3 ELEMENT CONNECTOR--The part number consists of the basic number of this specification sheet number plus a dash and the letter "C" to designate the element connector. EXAMPLE--SAE J2321/1-C identifies the filter element connector

Document information

  • Standard from SAE_AC
  • Published:
  • Version: 0
  • Document type: IS