Standard

SAE J2028

Revised

Note: This standard has a new edition: SAE J2028

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

1. Scope--This SAE Recommended Practice outlines recommended practices for qualification testing and performance related criteria of elastomeric boot seals integral to constant velocity joint applications in surface vehicles. Typically, these applications are referred to as front-wheel-drive halfshafts or axles, but can also be utilized in rear-wheel-drive halfshafts and propeller shaft applications. For additional information regarding CV joint systems and their applications refer to SAE AE-7 "Universal Joint and Driveshaft Design Manual." The grease quantities, clamps, and clamping mechanisms of an installation are considered to be the same as OEM or service designation. They are to be adequate and are not addressed in this document. Introduction--This Recommended Practice is intended as a guide toward performance related standard practice and is subject to change to keep pace with experience and technical advances. 1.1 Purpose--The purpose of this document is to establish a uniform practice for those in the surface vehicle industry that specify and/or manufacture CV joint boot seals (boots) for OEM or aftermarket use with respect to qualification testing for physical and mechanical properties.

Document information

  • Standard from SAE_AC
  • Published:
  • Version: 0
  • Document type: IS