It is currently not possible to order printed and bound versions of standards. This is due to challenges related to our printing supplier. We are working to resolve the situation and apologize for any inconvenience this may cause. For other options, contact salg@standard.no.
Standard

NS-EN ISO 10366-1:1999

Withdrawn

Note: This standard has a new edition: NS-EN ISO 10366-1:2002

Preview

Corrigenda and amendments are bought separately.

Language
Services

Abstract

1.1 This part of IS0 10366 establishes a system of designation for MABS thermoplastic material, which may be used for specifications. 1.2 The types of MABS plastics are differentiated from each other by a classification system based on appro- priate levels of the designatoty properties a) Vicat softening temperature b) melt flow rate c) impact strength d) flexural modulus and on information about basic polymer parameters, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials. 1.3 This part of IS0 10366 is applicable to all transparent methyl methacrylate/acrylonitrile/butadiene/styrene thermoplastic materials comprised of a continuous phase consisting of polymers of styrene (and/or an alkyl- substituted styrene), actylonitrile and poly(methyl methacrylate), and a dispersed elastomeric phase based on butadiene. It applies to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc. 1.4 It is not intended to imply that materials having the same designation give necessarily the same perform- ance. This part of IS0 10366 does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application and/or method of processing. If such additional properties are required, they shall be determined in accordance with the test methods specified in part 2 of this International Standard, if suitable. 1.5 In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements may be given in data block 5 (see clause 3, introductory paragraph).

Document information

  • Standard from SN
  • Published:
  • Withdrawn:
  • Edition: 1
  • Version: 1
  • Document type: NAT
  • ICS 83.080.20
  • National Committee SN/K 609

Product Relations

Product life cycle