It is currently not possible to order printed and bound versions of standards. This is due to challenges related to our printing supplier. We are working to resolve the situation and apologize for any inconvenience this may cause. For other options, contact salg@standard.no.
Standard

NS-EN 10247:2007

Withdrawn

Note: This standard has a new edition: NS-EN 10247:2017

Preview

Corrigenda and amendments are bought separately.

Language
Services

Abstract

This European Standard defines a method of microscopic non-metallic inclusion assessment using picture charts. The method does not apply to particles of a length less than 3,0 µm or a width smaller than 2,0 µm. Defined by a product standard or agreement between the involved parties for certain special products, inclusions with a width below 2,0 µm can only be evalua¬ted according to their length. Elongated inclusions with a length above 1 410 µm are counted separately and are beyond the upper application limit of this stan¬dard. Globular inclusions with a diameter of 3,0 µm and above are included in the assessment. It is assumed, if particles are elongated or if there are stringers of particles, they are parallel to each other. Other arrangements are not covered by this standard. This European Standard applies to samples with a microscopic precipitation approaching random distribution. From the data of measurements obtained by this method, evaluation according to other standards can be established. This European Standard should not apply for free cutting steels. NOTE The basic principle of this European Standard allows the determination of non-metallic inclusion content by image analysis techniques.

Document information

  • Standard from SN
  • Published:
  • Withdrawn:
  • Edition: 1
  • Version: 1
  • Document type: NAT
  • ICS 77.040.99
  • National Committee CEN/TC 459/SC 1

Product Relations

Product life cycle