Standard

AWWA C901

Published

Note: This standard has a new edition: AWWA C901

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

This standard describes polyethylene (PE) pressure pipe, tubing, and fittings, made from material having standard PE code designation PE4710* and intended for use in potable water, reclaimed water, and wastewater service. PE pipe ranges in nominal size from ¾ in. (19 mm)† through 3 in. (76 mm) and conforms to the outside-diameter (OD) dimensions of iron pipe size (IPS). PE tubing ranges in nominal size from ¾ in. (19 mm) through 2 in. (51 mm) and conforms to the OD dimensions of copper tube size (CTS). Fittings are produced in both pipe and tubing sizes under this standard. Included in this standard are criteria for classifying PE plastic pipe materials, a system of nomenclature for PE plastic pipe, and requirements and test methods for materials, pipe, tubing, and fittings. Methods of marking are also given. For larger sizes up to 65 in. (1,650 mm), refer to ANSI/AWWA C906.  Purpose  The purpose of this standard is to provide the requirements for materials, testing, inspection, and shipping of PE fittings and PE pipe (¾ in. [19 mm] through 3 in. [76 mm]) and PE tubing (¾ in. [19 mm] through 2 in. [51 mm]) for potable water, wastewater, and reclaimed water systems. * Earlier editions of ANSI/AWWA C901 included other PE material designations. For removed designations, refer to previous editions of ANSI/AWWA C901, ASTM D3350, PPI (Plastics Pipe Institute) TR-3, and PPI TR-4.  † Metric conversions given in this standard are direct conversions of US customary units and are not those specified in International Organization for Standardization standards.

Document information

  • Standard from AWWA_AC
  • Published:
  • Version: 0
  • Document type: IS