Standard

AWWA C521

Published

Note: This standard has a new edition: AWWA C521

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

This standard describes plastic ball valves for water supply service. This standard covers threaded, union, fusion, or compression ended double- and single-seated nonmetallic ball valves for pressures 100 psi (689 kPa) and higher in sizes from ½-in. through 2-in. (13-mm through 50-mm) diameter for use in potable water systems with temperatures greater than 32°F (0°C) and less than 125°F (52°C). Installation. The performance of products depends on proper installation. The purchaser must follow instructions supplied by or available from the manufacturer. If these instructions are not available, acceptable installation practices should be followed. Purpose The purpose of this standard is to define the minimum requirements for water supply service plastic ball valves, including materials, design, testing, and shipping.

Document information

  • Standard from AWWA_AC
  • Published:
  • Version: 0
  • Document type: IS