Standard

API MPMS 3.1B

Revised

Note: This standard has a new edition: API MPMS 3.1B

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

This standard covers level measurement of liquid hydrocarbons in stationary, aboveground, atmospheric storage tanks using automatic tank gauges (ATGs). The standard discusses automatic tank gauging in general, accuracy, installation, commissioning, calibration and verification of ATGs that measure either innage or ullage. It covers both intrusive and non-intrusive ATGs used for either custody transfer or inventory control. The standard also covers the requirements for data collection, transmission and receiving. This standard does not cover the following: a. Hydrocarbons having a Reid vapor pressure above 15 pounds per square inch absolute (100 kPa). b. Measurement of weight or mass with ATG equipment. This is covered in Chapter 3.6 and Chapter 16.2 of the Manual of Petroleum Measurement Standards. c. Measurement of level in underground tanks or in pressurized tanks storing liquid hydrocarbons. d. Conversion of tank level to liquid volume. This is covered in Chapter 12.1 of the Manual of Petroleum Measurement Standards. e. Measurement of temperature, sampling, density and sediment and water (S & W), which are discussed in Chapters 7-10 of the Manual of Petroleum Measurement Standards. Safety and material compatibility precautions should be taken when using ATG equipment. Manufacturer's recommendations on the use and installation of the equipment should be followed. Users should comply with all applicable codes and regulations, API Standards and NFPA 70 National Electric Code.

Document information

  • Standard from API_AC
  • Published:
  • Version: 0
  • Document type: IS
  • Additional information
    • Second Edition