Standard

NS-EN 10034:1993

Publisert

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

This European standard specifies tolerances on shape dimensions and mass of structural steel I and H sections. These requirements do not apply to I and H sections rolled from stainless steel. These requirements do not apply to taper flange sections. Note: Until a European standard for dimensions of I and H beams is published, Euronorm 19 and Euronorm 53 or corresponding national standards may be used.

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Utgave: 1
  • Versjon: 1
  • Varetype: NAT
  • Products.Specs.pages
  • ICS 77.140.70
  • National Committee CEN/TC 459/SC 3

Produktrelasjon

  • Adoptert fra: EN 10034:1993, 0