Standard

SAE AMS5617L

Publisert
For bestilling og priser av dette produktet ta kontakt med salg@standard.no

Omfang

Form This specification covers two grades of a premium aircraft-quality, corrosion-resistant steel in the form of bars, wire, forgings in the solution heat treated condition, and forging stock. Product covered by this specification is limited to a nominal 6.00 inches (152.4 millimeters) and under diameter or maximum cross-sectional dimension between parallel sides (thickness), unless the product is tested in the response to H1000 condition (see 3.5.1.2 and 8.7). When product is tested in the H1000 condition, the product is limited to 8.00 inches (203.2 millimeters) and under diameter or maximum cross-sectional dimension between parallel sides (thickness). Stock for forging may be of any size. Application These products have been used typically for parts requiring corrosion resistance and high strength up to 800 °F (427 °C). The steel can be precipitation hardened to minimum tensile strengths up to 225 ksi (1551 MPa). Certain design and processing procedures may cause these products to become susceptible to stress-corrosion cracking after heat treatment; ARP1110 recommends practices to minimize such conditions. Classification Steels covered by this specification are classified as follows: Grade 1: Transverse ductility, not specified Grade 2: Transverse ductility, specified Unless a specific type is ordered, Grade 1 shall be supplied for product under 3.00 inches (76.2 mm) in nominal diameter, or least distance between parallel sides, and Grade 2 shall be supplied for larger sizes.

Dokumentinformasjon

  • Standard fra SAE_AC
  • Publisert:
  • Versjon: 0
  • Varetype: IS
  • Tilleggsinformasjon
    • (Composition similar to UNS S45500, S45503)