Standard

SAE AMS4040R

Publisert
For bestilling og priser av dette produktet ta kontakt med salg@standard.no

Omfang

Form This specification covers an aluminum alloy in the form of sheet and plate, alclad two sides, 0.188 to 1.000 inch (4.775 to 25.400 mm), inclusive, in thickness, supplied in the annealed (O) condition (see 8.5). Supersession Notice Requirements for thin gauge sheet (0.008 to 0.187 inch) in accordance with AMS4040 are superseded by AMS4461. AMS-QQ-A-250/5 and AMS4461 have the same requirements for alclad thickness and tensile properties for material less than 0.187 inch in thickness. AMS4040 covers alclad material for sheet in thicknesses of 0.188 inches (4.775 mm) and greater and plate up to 1.000 inch (25.400 mm), inclusive. The cladding thickness is minimized to provide a commensurate increase in tensile properties for this alclad reduction. Use of this product is not recommended without proper evaluation of corrosion resistance. Application These products have been used typically for formed structural parts that will be subsequently heat treated, but usage is not limited to such applications. Certain design and processing procedures may cause these products to become susceptible to stress-corrosion cracking after heat treatment; ARP823 recommends practices to minimize such conditions.

Dokumentinformasjon

  • Standard fra SAE_AC
  • Publisert:
  • Versjon: 0
  • Varetype: IS
  • Tilleggsinformasjon
    • (Composition similar to UNS A82024)