Handlevagon 0
Viktig melding eBlankett-systemet oppdateres fra og med fredag 27. desember til og med søndag 29. desember. Vi oppfordrer til ikke å bruke eBlankett-systemet i denne perioden. Fylles det ut informasjon i blankettene i perioden kan informasjonen bli borte.
Standard

NS-EN ISO 8662-7:1997

Tilbaketrukket
Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

This part of iso 8662 specifies a laboratory method for measuring vibration et the handles of wrenches, screwdrivers and nut runners with impact, impulse, rapping or ratchet action. It is a type-test procedure for establishing the vibration value at the handles of the power tools when operating on a specified load. This part of ISO 8662 mainly covers power tools with 6.3 mm to 40 mm (1/4 in to 1 1/2 in) male or female square-drive output shafts: other drive geometries are also included. One-shot tools and stall-torque-type ratched wrenches are excluded from this part of ISO 8662. The power tools covered by this part of ISO 8662 may be pneumatically or hydraulically driven. It is intended that the results be used to compare different power tools or different models of the same power tool. With the operation specified for the power tools, the values obtained will give an indication of those found in real work situations when the power tool and the head of the fastener are well aligned.

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Tilbaketrukket:
  • Utgave: 1
  • Versjon: 1
  • Varetype: NAT
  • Products.Specs.pages
  • ICS 13.160
  • ICS 25.140.01
  • ICS 25.140.10
  • National Committee CEN/TC 231/WG 2

Produktrelasjon

Produkt livssyklus