Handlevagon 0
Standard

ISO/DIS 2507

Utkast

Merknad: Denne standarden har en ny utgave: ISO 2507:1982

Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

The method specified is based on determining the temperature at which a standard indenter, under a force of 50 N ± 1 N, penetrates 1 mm into the surface of a test piece cut from the wall of a pipe or fitting while the temperature is raised at a constant rate. Is applicable only to thermoplastics materials for which it is possible to measure the temperature at which the rate of softening becomes rapid. Is based on ISO 306:1994 which, however, applies to materials in the form of sheets.

Dokumentinformasjon

  • Standard fra ISO
  • products.specs.Expires:
  • Utgave: 3
  • Versjon: 1
  • Varetype: IS
  • Products.Specs.pages
  • ICS 23.040.45
  • ICS 23.040.20
  • ISO TC ISO/TC 138/SC 5

Produktrelasjon

Produkt livssyklus