Standard

SSPC AMPP PS 26.00

Published

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

This standard covers the requirements for an ambient-temperature cure, two-component aluminum pigmented epoxy coating that is intended for use as a single or multi-coat system on carbon steel. Coating systems meeting this standard are suitable for exposures in SSPC Environmental Zones 1A (interior, normally dry), 1B (exterior, normally dry), 2A (frequently wet by fresh water, excluding immersion), 2B (frequently wet by salt water, excluding immersion), and 3B (chemical exposure, neutral (see Appendix A [nonmandatory]) as well as ISO 12944-3 equivalent environments. The specified coating system is intended for application by brush, spray, or roller (see Paragraph A2). Type I is for use over steel surfaces blast cleaned to SSPC-SP 6 or better (see Paragraph A3). Type II is for use over non-blast cleaned as well as blast cleaned steel surfaces, i.e., surfaces cleaned to SSPC-SP 2 or better (see Paragraph A4). For either Type I or Type II, the surface should be prepared in accordance with the manufacturer’s written recommendations.

Document information

  • Standard from SSPC_AC
  • Published:
  • Version: 0
  • Document type: IS