This is a Norwegian Prestandard
The Norwegian Prestandard SN-EN 1999-1-1:2023 represents a second-generation Eurocode. Prestandards (SN-EN) for second-generation Eurocodes are published to provide the industry with an opportunity to familiarize itself with the content. These prestandards do not replace the first-generation Eurocodes.
Follow this link for the valid version of NS-EN 1999-1-1.
In Norway, all second-generation Eurocodes will be published collectively as Norwegian Standards (NS-EN) along with corresponding national annexes. All first-generation Eurocodes with national annexes will remain valid Norwegian standards until then and will be withdrawn simultaneously with the publication of the second-generation Eurocodes.
Abstract
1.1 Scope of FprEN 1999-1-1(1) FprEN 1999-1-1 gives basic design rules for structures made of wrought aluminium alloys and limited guidance for cast alloys (see Clause 5 and Annex C).This document does not cover the following, unless otherwise explicitly stated in this document:- components with material thickness less than 0,6 mm;- welded components with material thickness less than 1,5 mm;- connections with:- steel bolts and pins with diameter less than 5 mm;- aluminium bolts and pins with diameter less than 8 mm;- rivets and thread forming screws with diameter less than 3,9 mm.1.2 Assumptions(1) In addition to the general assumptions of EN 1990 the following assumptions apply:- execution complies with EN 1090-3 and EN 1090-5;- the mechanical properties comply with the product standards listed in 5.2.2.(2) EN 1999 is intended to be used in conjunction with:- European Standards for construction products relevant for aluminium structures;- EN 1090-1, Execution of steel structures and aluminium structures - Part 1: Requirements for conformity assessment of structural components;- EN 1090-3, Execution of steel structures and aluminium structures - Part 3: Technical requirements for aluminium structures;- EN 1090-5, Execution of steel structures and aluminium structures - Part 5: Technical requirements for cold-formed structural aluminium elements and cold-formed structures for roof, ceiling, floor and wall applications.