Standard

SAE AS39029E

Published

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

Contacts covered by this specification are primarily intended for use in multi-contact connectors where the coupling means is provided separately from the individual contact. Specific application and mating contacts will be included for information in the specification sheets. Contacts that are an integral part of the connector are not intended to be qualified to this specification; however, these contacts may be tested as required (see 3.1). Type B Contact Test Currents Type B contact test currents (see Tables 7 and 8) are reduced to the equivalent of one full wire size rating to compensate for inherent increased resistivity of these contacts. The use of full test current (see Tables 5 and 6) on these contacts may result in overheating. Type D Shielded Contacts Type D contacts are coaxial contacts for use in multi-contact connectors. These contacts are for use to shield the circuit from unwanted interference (RFI and EMI). These contacts are not impedance matched and, therefore, are not recommended for RF use. Contacts with Size 28 and Smaller Wire Contacts with size 28 and smaller wire are not for use in random vibration and shock application.

Document information

  • Standard from SAE_AC
  • Published:
  • Version: 0
  • Document type: IS