Standard

SAE AMS7379A

Published

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

Form This specification covers a fluorocarbon (FKM) rubber in the form of O-rings, compression seals, O-ring cord, and moldedin- place gaskets for aeronautical and aerospace applications. For sheet, strip, tubing, extrusions, and molded shapes use the AMS3353 specification which is intended for that use. Application This material has exhibited excellent low temperature functionality along with resistance to a variety of gas turbine engine oils, including high thermal stability (HTS) oils, fuels, and hydraulic fluids, but usage is not limited to such applications. This material has a typical service temperature range of -50 to +400 °F (-45 to +204 °C). The service temperature range of the material is a general temperature range, but the presence of particular fluids and design parameters may modify this range. Each application should be considered separately. It is the responsibility of the user to determine that this specification is appropriate for the environments (temperature range, fluids exposure, etc.) in which it is sought to be used. Order of Precedence Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. This specification is in addition to and in no way limiting, superseding, or abrogating any contractual obligation as required by the applicable procurement document. In the event of conflict in requirements, the order of precedence shall be: 1. Procurement Document or Contractual Agreement and all statutory and regulatory requirements (excluding this document). 2. Applicable purchaser’s drawing or AS5729 Parts Standard. 3. Specification referenced on the drawing. 4. This document. 5. All specifications referenced in this document. Safety-Hazardous Materials While the materials, methods, applications, and processes described or referenced in this specification may involve the use of hazardous materials, this specification does not address the hazards which may be involved in such use. It is the sole responsibility of the user to ensure familiarity with the safe and proper use of any hazardous materials and to take necessary precautionary measures to ensure the health and safety of all personnel involved.

Document information

  • Standard from SAE_AC
  • Published:
  • Version: 0
  • Document type: IS