Standard

SAE AMS7361B

Published

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

Form This specification covers an ethylene propylene rubber in the form of molded rings, molded compression seals, molded O-ring cord, and molded-in-place gaskets for aeronautical and aerospace applications. Application This material has resistance to AS1241 Type IV Class 1 and Type V Grade A and Grade B phosphate ester fluids, but usage is not limited to such applications. This material is not intended for use in AS1241 Type IV Class 2 fluids. This material has an expected service temperature range of -75 to 250 °F (-59 to 121 °C), with excursions up to 300 °F. The expected low temperature limit is derived from an industry practice of using 15 °F (8 °C) below the temperature retraction (TR10). The service temperature range of the material is a general temperature range, but the presence of particular fluids and specific design requirements may modify this range. Each application should be considered separately. This specification is intended for use in static applications and was developed to provide an ethylene propylene rubber compound for hydraulic seals with improved low temperature performance. It has not been evaluated for dynamic applications. It is the responsibility of the user to determine that this specification is appropriate for the environments (temperature range, fluids exposure, dynamic usage, etc.) in which it is sought to be used. Order of Precedence Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. This specification is in addition to and in no way limiting, superseding, or abrogating any contractual obligation as required by the applicable procurement document. In the event of conflict in requirements, the order of precedence shall be: 1. Procurement document or contractual agreement and all statutory and regulatory requirements (excluding this document) 2. Applicable purchaser’s drawing or parts standard 3. Specification referenced on the drawing 4. This document 5. All specifications referenced in this document Safety Hazardous Materials While the materials, methods, applications, and processes described or referenced in this specification may involve the use of hazardous materials, this specification does not address the hazards which may be involved in such use. It is the sole responsibility of the user to ensure familiarity with the safe and proper use of any hazardous materials and to take necessary precautionary measures to ensure the health and safety of all personnel involved.

Document information

  • Standard from SAE_AC
  • Published:
  • Version: 0
  • Document type: IS