Standard

SAE AMS4311G

Published

Singles purchase not accessible

This standard can not be purchased as a single sales.

Abstract

Form This specification covers an aluminum alloy in the form of rolled or forged rings up to 6 inches (152 mm), inclusive, in nominal thickness at the time of heat treatment and having an OD to wall thickness ratio of 10 or greater (see 8.6). Application These rings have been used typically for applications requiring a combination of high strength, resistance to stress-corrosion cracking, and good stability during machining, but usage is not limited to such applications. Classifications Rings are classified by type of mechanical stress relief as follows: Type 1 - Stress relieved by stretching (7075-T7351) Type 2 - Stress relieved by compression (7075-T7352) Either type may be supplied unless a specific type is ordered (see 8.6).

Document information

  • Standard from SAE_AC
  • Published:
  • Version: 0
  • Document type: IS
  • Additional information
    • (Composition similar to UNS A97075)